The PROFIBUS Tester 5 (BC-700-PB) is a powerful PROFIBUS diagnostic and troubleshooting tool for testing the cables, measuring the signals and analyzing the communication of PROFIBUS networks. It is battery-powered and provides a graphical display, allowing for quick results when working in stand-alone mode. Optionally, also PROFIBUS PA network can be analyzed. In addition, the PROFIBUS Tester 5 supports the export of test results for advanced analysis.
|Scope of Delivery|
|Hardware||PROFIBUS Tester 5 (BC-700-PB), power supply unit 100 VAC ... 240 VAC, 50/60 Hz with connecting cables for Europe and USA, adaptor cables, carrying case, measuring adapter BC-700-H1, measuring cable set (for PROFIBUS PA option)|
|Software||PROFIBUS Diagnostics Suite (PC software for Windows on CD-ROM)|
PROFIBUS Tester 5 (BC-700-PB) upgrade license (on CD-ROM, for PROFIBUS PA option)
|Documentation||Device manual, “Getting Started“ manual|
|DDA-NN-006014||PROFIBUS Tester 5 (BC-700-PB)|
|Additional Products and Services|
|LRA-NN-006011||License Oscilloscope Option|
|DDL-NL-006010||License PA-Option (+ cable set)|
|ACA-NN-006033||D-Sub to M12 adapter set with T-piece and M12 bus termination for PROFIBUS DP|
|DDA-ZZ-004010||Digital Fieldbus Leakage Current Clamp for Locating EMC Problems, 40 ..1000 Hz, MIN/MAX, Data Hold, Measuring Cables, supplied in a Handy Case (fi ts in Empty Compartment of Carrying Case)|
|ACL-NN-006037||D-Sub Service Interface with Active Bus Termination and 90° Angled Connector for PROFIBUS DP|
|ACA-NN-006034||M12 Service Interface for PROFIBUS DP, Comprising M12 T-Piece, End Cap and M12 Connection Cable (1 m)|
|ACA-NN-006031||EIA-485 D-Sub adapter cable for testing operational networks with reduced influence on segment operation|
Measures leakage currents, e.g. leakage and fault currents, and current pick-up of instruments without breaking the circuit. Measurements according to DIN VDE 0701/0702 and the German BetrSichV (BGV A3, VBG 4).
Digital leakage current clamp, 2 batteries 1.5 V IEC LR6, carrying case, measuring cables (1 x red, 1 x black) and user manual.
Provides an access point for testing PROFIBUS networks if the D-sub connectors have no service socket or if the stations are connected via terminal block.
The service interface is top hat rail mounted. An external 24 VDC power source is required for power supply to the terminating resistor in the PROFIBUS connector included in the package. The service interface can thus be used as an active bus termination at the beginning or end of the bus. If the PLC allows dropping and adding bus stations on the live bus, the service interface offers the possibility to exchange the first and last bus stations without causing problems on the bus.
PBMB adapter and 90° angled PROFIBUS connector with switchable terminating resistor, strain relief and screw terminal technology.
Provides an access point for testing PROFIBUS networks with M12 connectors.
The service interface is inserted between two bus stations. When not in use, the service output of the T piece is closed with an end cap. At baud rates of 1.5 Mbit/s or higher, use the supplied cable to ensure that the required minimum distance between bus stations is maintained.
T piece (protection class IP68) with end cap and a 1 m DP cable fitted with a male/female M12 connector on each end.